- Quick and simple installation to seal and waterproof a termination
- High resistance to tearing and high tensile strength
- Resistant to UV, decay, chemicals and corrosion
KEV Heatshrink Boot/Glove 4 Way 69-29MM/25-8.5MM
KEV Heatshrink Gloves (boots) are used to seal and waterproof cable
terminations, by sealing the insulated conductors to the cable jacket. They
have a hot melt glue liner that melts while the glove is shrinking and creates
a strong bond between the glove and the cable.
Features:
• Quick and simple installation to seal and waterproof a termination.
• High resistance to tearing and high tensile strength.
• Resistant to UV, decay, chemicals and corrosion.
Instructions:
To install the glove, ensure that the insulation of the cable and conductor
are clean and grease-free, and roughen with emery paper for a good glue bond.
Shrink the glove from the middle out with a heat gun or soft yellow gas flame
until adhesive extrudes. Avoid local overheating during the shrinkage process.
Technical Data:
Conformant Standards: ASTM & IEC
Material: Modified cross-linked polyolefin
Continuous Operating Temp: -40°C to +110°C
Min. Full Recovery Temp: 120°C
Tensile Strength: 14 MPa
Ultimate Elongation: 600%
Dielectric strength: 17 kV/mm
Volume Resistance: 3.0 x 1014 Ω.cm
Water Absorption: 0.3%
Flammability: Do not use in flame prone areas
Line drawings available. See Technical Data.
Heatshrink Colour: | Black |
---|---|
Heatshrink Type: | 4-Way Breakout Boot |
Pre-Shrink Diameter (mm): | 65 |
After-Shrink Diameter (mm): | 26 |
Heatshrink Tube Length (M): | 0.175 |
Recovered Wall Thickness (mm): | 3.3 |
Glue Lined: | Yes |
Your ordered quantity for this item is more than what we have in stock.
Stock Availability
Location | |
---|---|
Please contact us to know more about this item's availability or possible restock dates.