Glove 4 Way 90-37/32-11mm

KEV Heatshrink Boot/Glove 4 Way 90-37MM/32-11MM

KEV Heatshrink Gloves (boots) are used to seal and waterproof cable terminations, by sealing the insulated conductors to the cable jacket. They have a hot melt glue liner that melts while the glove is shrinking and creates a strong bond between the glove and the cable.

Features:
• Quick and simple installation to seal and waterproof a termination.
• High resistance to tearing and high tensile strength.
• Resistant to UV, decay, chemicals and corrosion.

Instructions:
To install the glove, ensure that the insulation of the cable and conductor are clean and grease-free, and roughen with emery paper for a good glue bond. Shrink the glove from the middle out with a heat gun or soft yellow gas flame until adhesive extrudes. Avoid local overheating during the shrinkage process.

Technical Data:
Conformant Standards: ASTM & IEC
Material: Modified cross-linked polyolefin
Continuous Operating Temp: -40°C to +110°C
Min. Full Recovery Temp: 120°C
Tensile Strength: 14 MPa
Ultimate Elongation: 600%        
Dielectric strength: 17 kV/mm
Volume Resistance: 3.0 x 10¹⁴ Ω.cm
Water Absorption: 0.3%
Flammability: Do not use in flame prone areas

Line drawings available. See Technical Data.