Crimped with CABAC and MSS Power standard tooling and dies
Suitable for fine strand conductors
Bellmouth makes insertion easier
Copper Bell Mouth Lug for Stranded Cable
Designed to accommodate fine stranded flexible cable which tends to splay out after stripping. The special bell mouth funnel makes conductor insertion easy.
At the top end of the cable diameter range (around 150 to 240mm2) some manufacturers cables will not fit into the nominal lug. In this case CABAC recommends using one lug size up, and using the special crimping method described in the 'Crimping Fine Stranded Cable' fact sheet (see Useful Information above). More information is available from our Sales Team.
Please Note: Fine stranded cables need a higher crimping force so tools have to be de-rated from normal accepted crimping capacity.
Standards and Compliance
Test reports are available on request
Nominal Conductor (mm2): 10
ID Size (mm): 4.7
Stud (mm): 6
Qty Per Box: 100
Copper 99.95% pure
Oxygen content 30 p.p.m Max.
Tensile strength 200 MPa
Ductile rating 40%
Final metal state fully annealed
Tin 99.9% pure
Other metals lead + antimony
Thickness 5 -10 microns
General Electrical Properties
Total conductivity 99.7% IACS
Total resistivity: 1.738 micro-ohm cm
-55 to 155 deg C due to oxygen-free copper
Tooling is interchangeable between CABAC, Utilux and Burndy
|Stud Size (mm):||6|
|Cable Size (mm2):||10|
|Lugs and Links - Material:||Copper|
Please contact us to know more about this item's availability or possible restock dates.