- Must be used with S-Click 2-wire and S-Click 3-wire timer mech's HNS410TM, HNS420TM, HNS440TM or HNS450TM
- Senses movement and light to trigger S-Click timer mech's
- Fits in standard HPM and Clipsal face plates with lenses
- Designed, engineered and manufactured in Australia
The HNS050MD is a light sensitive motion detector that provides automatic, hands-free switching of S-Click minute or hourly timers. When an area is in use and natural light is insufficient, the HNS050MD will trigger the timer to turn lighting on for a pre-programmed period of time. The timer is typically set to time out after 30 minutes or 1 hour.
The HNS050MD uses passive infra-red (PIR) technology to detect motion up to two metres from the sensor and acts as a light level detector to determine if the ambient light is low enough for lighting to be required. This does not prevent normal operation of the timer. If natural light is present but additional lighting is needed, the timer can be initiated with a quick tap of the button as normal.
This motion detector is designed to provide maximum power savings and has an extremely low standby power consumption of less than 100mW.
Applications and Compatibility
The HNS050MD is ideal for use in areas where natural light is periodically available, such as offices, work spaces, meeting rooms, hallways and garages. A light sensitive PIR detector is able to conserve energy in these settings by detecting the light level and only starting the timer switch when movement is detected whilst the area is dark (< 20 lux).
The HNS050MD must be used with one of the timer switches listed below. It cannot be used on its own.
HNS410TM - Minute Timer 2-Wire
HNS420TM - Hourly Timer 2-Wire
HNS440TM - Minute Timer 3-Wire
HNS450TM - Hourly Timer 3-Wire
Multiple S-Click motion detectors can be used with a single S-Click timer, refer to the product datasheet for more information.
The HNS050MD fits in standard HPM and Clipsal face plates - matching lenses included.
Operating Voltage: 220 - 240Va.c. 50Hz
Operating Temperature: 0 to +50 degrees Celsius
Certified Standards: CISPR15, AS/NZS 3100
Maximum Load: As per connected S-Click Timer Switches
Note: Operation at temperature, voltage or load outside of the specifications may cause permanent damage to the unit.
The HNS050MD is to be installed as part of a fixed wire electrical installation. By law such installations must be made by an electrical contractor or similarly qualified person. For installation instructions, operating instructions and important safety warnings, refer to the product user manual (see Additional Information).
|Max Current (A):
|Operating Voltage (V):
Your ordered quantity for this item is more than what we have in stock.
Please contact us to know more about this item's availability or possible restock dates.